An automatic switch-off function prevents
rapid discharge of the batteries.
The LC display is particularly professional. This
eases the display of phase and phase sequence for all service or installation
engineers.As of a voltage of 35V AC/DC an acoustic signal sounds to signalise
a voltage which is life-threatening. The switchable load per switch prevents accidental
triggering of the residual current circuit breaker ensuring that the protective
conductor can be measured.
Advantages:
• Display of direct and alternating currents of 6 to 1000 Volts
• Single-pole phase check
• Dual-pole phase sequence check
• Throughput check to 150 Ohm (acoustic)
• Resistance measurement up to 2000 Ohm
• Diode testing
• Data-hold function
• Display illumination
• Residual current circuit breaker/RCD test using two buttons
• LED torch (white)
• Unscrewable 4 mm test tip adapter
• Automatic power off function
| Technical data |
Profi LCD Plus |
| Display |
Optical, 3 1/2 digits, LCD |
| Operating panel |
Finger contact, residual current circuit breaker/RCD
button, ON/OFF button, D-H button |
| Measuring range |
Automatic measurement range selection |
| Voltage range |
6 -1000V AC/DC, 0 - 400Hz |
| Resistance test |
0 - 2000Ω |
| Throughput check |
0 ~ 150Ω with acoustic signal |
| Phase display |
> 100V AC |
| Switchable load |
Is ~ 30mA ED(DT) = 30 sec. |
| Power supply |
2x 1,5V |
| Overvoltage category |
CAT IV 1000V |
| Dimensions |
238 x 70 x 30 mm |
| Protection class |
IP 65 |
| Weight |
200 g |
| Test |
TÜV/GS tested and approved
IEC/EN 61243 - 3 (DIN VDE 0682-401) |
| Scope of delivery |
1x Operating instructions
2x Batteries type AAA Micro |
| Guarantee |
3 years |
|
