Art. no. 21 08 33
 

Crimp-Grip pliers


Description
With final-point for processing of uninsulated terminals blades of 0.05 - 6 mm², one way process for contact- and isolation-crimping, with cable cutter and wire stripping device for wire up to 6 mm², roll crimping.


Crimping range: 0.05 - 6 mm²

Crimping pliers for uninsulated open brass cable lugs
We distinguish between wire crimps and insulation crimps. The end of the wire should be flush with the wire crimp or extend beyond it no further than 1 mm, so that the plug function is not affected. The insulation end must not project into the wire crimp, however it must
also not lie just half beneath the insulation crimp. Only in this way can a standard-compliant crimp be ensured. In a good crimp the wire must be deformed. In this case one talks of a“gastight crimp”. To ensure precise crimping of open plug-in connections, locators can
be attached to the pliers.

Do you have any questions?
info@haupa.com