Art. no. 20 01 70
 

Bolt cutter


 
Description
• Cuts soft and hard wires, piano wire
• Cuts bolts, nails, rivets etc. up to Ø 3.6 mm

• Particularly high cutting performance with low force required thanks to extremely effective joint construction
• Blades are also inductively hardened, blade hardness approximately 64 HRC
• Chrome vanadium high-performance steel, forged, oil-hardened
• Length: 200 mm
• Ø 3.6 mm

In cutting, a distinction is made between a drawing cut and a pushing cut. When the cutting motion is carried out at an angle to the tool, this is a drawing cut. However, if the cutting motion is carried out vertically to the tool this is a pushing cut.

Do you have any questions?
info@haupa.com