Art. no. 20 01 78
 

Special cable cutter


Video
Description
Complete set:
• Universal cable cutter
• 1 pair of cutting segments S1 (Art. 200178/S1)
• Cleaner

Art. no. 200178

• Length: 230mm, Ø 50mm, 300 mm², fine wiring 240 mm²
• Cable cutter for exchangeable cutting segments
• Cuts crush-free copper and aluminium cables up to a diameter of 50 mm
• Optimum blade geometry for high-performing offset translation
• Patented structure for exchangeable cutting segments
• For steel encased/steel armoured wires, cables and hoses
• 12/14 mm wide drive resists even the greatest of loads
• With tooth comb for cleaning teeth
• ACSR

Further accessories for art. no. 200178

Art. no. 200178/S1
• Cuts soft and hard wires, piano wire
• Cuts bolts, nails, rivets etc. up to Ø 3.6 mm
• Particularly high cutting performance with low force required thanks to extremely effective joint construction
• Blades are also inductively hardened, blade hardness approximately 64 HRC
• Chrome vanadium high-performance steel, forged, oil-hardened
• Steel armoured tubing: Ø 50 mm
• Can lead to crimping of steel cables are highly flexible, slightly edgy cut-away section, increased handgrip
• 300 mm²

Art. no. 200178/B
Application:

• AL/CU: Cross-section 150 mm, Ø 30 mm
• Flexible steel cables: Cross-section 70 mm, Ø 12 mm
• Supporting cable: Cross-section 70/300 mm², Ø 12/30 mm, Type 8
• ACSR DIN 48 204: Cross-section 70/12 mm², Ø 11.7 mm, 7/1.44 mm
• 150 mm²

Art. no. 200178/C
Application:
• AL/CU: Cross-section: 350 mm, Ø 50 mm
• Clean cut and low handgrip with large cross sections, suitable for highly flexible conductors; not for steel
• 350 mm²

Art. no. 200178/S
Application:
• AL/CU: Cross-section 350 mm, Ø 50 mm
• Flexible steel cables: Cross-section 95 mm, Ø 16 mm
• Cable with soft steel sleeve: Cross-section 240 mm², Ø 50 mm
• Clean cut and normal handgrip
• 350 mm²

Art. no. 200178/S2
Application:
• AL/CU: Cross-section 200 mm², Ø 50 mm
• Flexible steel cables: Cross-section 95 mm², Ø 14 mm
• Niro cables: Ø 8 mm, 19/1
• ACSR DIN 48 204: Cross-section 300/50 mm², Ø 24.5, 7/3 mm
• Steel armoured tubing: Ø 50 mm
• Construction steel 235JR+AR: Ø 10 mm, full material
• Screws: Ø 8 mm, 8.8
• Can lead to crimping of steel cables are highly flexible, slightly edgy cut-away section, increased handgrip
• 200 mm²

Benefits:
• Cutting without crushing
• Small and large cable cross-sections can be handled without need for strength
• Mature technology
• Pin-mounted engine components
• Special cutting geometry
• Optimised eccentric drive
• Permanently forged cogs
• High lifetimes
• Low maintenance requirements

Do you have any questions?
info@haupa.com