Art. no. 20 01 79

Cable cutter

Almost maintenance-free quality tool up to 100 mm Ø. Smooth-running due to needle-bearing eccentric drive, also suitable for cables with steel plate jacket and soft steel wire reinforcement, ST 52. Comes with cog comb to clean cogs, integrated in the handle.

mm² Ø mm
Cutting range: Cu/Al wire multi wiring 1400 100
Cu/Al wire sector format 1400 100
Cu wire fine wiring 1400 100
Cu wire fine wiring or telecommunication cable 100
Length: 610 mm
Weight: 3322 g

• Cutting without crushing
• Small and large cable cross-sections can be handled without need for strength
• Mature technology
• Pin-mounted engine components
• Special cutting geometry
• Optimised eccentric drive
• Permanently forged cogs
• High lifetimes
• Low maintenance requirements

Do you have any questions?